CONFIGURATION134.1.4 Sending Configuration Strings from HostAn alternative configuration method is provided in Appendix A using the RS232interface. This method is particularly useful when many devices need to beconfigured with the same settings. Batch files containing the desired parametersettings can be prepared to configure devices quickly and easily.4.2 SETUP PROCEDURESFor Gryphon™ D-Series readers, follow the setup procedures in pars. 4.3 and 4.6.For Gryphon™ D USB readers, follow the setup procedures in par. 4.7.For Gryphon™ M-Series readers, the setup procedures depend on two basicapplications, Stand Alone or STAR-System™.Stand Alone applications allow communication with the Host by either theOM-Gryphon™ cradle (par. 4.4), or by the STAR-Modem™ radio modem(par. 4.4.2).STAR-System™ applications allow communication with the Host through an RS485network by the STARGATE™ RF base station or by the STAR-Modem™ radiomodem (par. 4.5).Proceed as shown in the following diagram:E nd o f S etupY our reader is now ready to readbarcodes using the default settings.S tand Alon e Ap plicationsG R Y P H O N ™ M /O M -G R Y P H O N ™P ar. 4.4P ar. 4.6O p tio n al P ar. 4.4.1m ultiple guns per O M -G R Y P H O N ™G R Y P H O N ™ M /S T AR -M o d em ™in S tand A lone M odeP ar. 4.4.2G R Y P H O N ™ DP ar. 4.3P ar. 4.6S TAR -S ystem ™ Application sG R Y P H O N ™ M /S T AR -S ystem ™P ar. 4.5• S TA RG ATE ™• S TA R-M odem ™ in STA R-System ™ M odeG R Y P H O N ™ D U SBP ar. 4.7B eg in S etu p by choosing the setupprocedure for your G R Y P H O N ™reader as indicated below.
