5-10 Magellan® 9500Decreasing-Load TestThis test ensures that the scanner/scale responds properly when a heavyobject is followed by a significantly smaller object.1. Place a 30.0-pound load on the scale and verify that the displayshows between 29.99 and 30.01 pounds.2. Remove weights to leave 20 pounds on the scale. Check that the dis-play shows between 19.99 and 20.01.3. Remove another 15.0 pounds from the scale and check that the scalereads 5.00 lb.4. You have completed the Decreasing Load Test.Return to Zero TestThis test ensures that, after all other tests have been completed success-fully, the scanner/scale returns to zero. Remove all weights from the scaleand verify that the scale reads 0.00 lb.After completing this test, close the calibration access cover and seal perlocal Weights and Measures requirements. This final step must agree withthe legal requirements of your state or local government.You have completed the calibration and verification process for weighingin pounds.If the scanner/scale passes all these tests,1. Remove the weigh platter, install the calibration switch cover andinstall a seal (if required).2. Reinstall the weigh platter.If the scanner/scale fails any of these tests, it should be serviced by a quali-fied technician.NOTEIf the upper weight limit for your scale is not set at 30 pounds, begin by plac-ing weight equaling your upper limit setting.
