Enter/Exit Programming Mode42 PowerScan™ PD9130/PBT9100/PM9100Wedge Quiet IntervalSpecifies amount of time to look for keyboard activity before scanner breakskeyboard connection in order to transmit data to host. The selectable rangefor this setting is 00 to 990 milliseconds (00-0x63 by 01) in increments often milliseconds. See page 294 in “References” for detailed information andexamples for setting this feature.Set Wedge Quiet IntervalTo configure this feature, scan the ENTER/EXITPROGRAMMING MODE bar code above, thenthe bar code at left followed by the digits fromthe Alphanumeric characters in Appendix D,Keypad representing your desired character(s).End by scanning the ENTER/EXIT bar codetwice.Make a mistake? Scan the CANCEL bar code toabort and not save the entry string. You canthen start again at the beginning.CANCEL0A = Quiet Interval is100 millisecondsDEFAULTIntercode DelaySpecifies the delay between labels transmitted to the host for this interface.The selectable range for this feature is from 0 to 99 seconds.See page 296 in “References” for detailed information and examples for set-ting this feature.Set Intercode DelayTo configure this feature, scan the ENTER/EXITPROGRAMMING MODE bar code above, thenthe bar code at left followed by the digits fromthe Alphanumeric characters in Appendix D,Keypad representing your desired character(s).End by scanning the ENTER/EXIT bar codetwice.Make a mistake? Scan the CANCEL bar code toabort and not save the entry string. You canthen start again at the beginning.CANCEL00 = No Wedge Intercode DelayDEFAULT
