Datalogic PowerScan PD9530 Product Reference Manual

Also see for PowerScan PD9530: Product reference guide Product reference guide Product reference guide Product reference guide Quick reference guide

Contents

Datalogic PowerScan PD9530 Product Reference Manual Manual pdf 234 page image

References232 PowerScan™ PD9530Flash On TimeThis feature specifies the ON time for the indicator LED while in Flash Mode. Theselectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecondincrements.Follow these instructions to set this feature.1. Determine the desired setting in milliseconds.2. Divide the desired setting by 100 (setting is in 100ms increments). Pad the result withleading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.3. Go to page 71 and scan the ENTER/EXIT PROGRAMMING MODE bar code toenter Programming Mode.4. Scan the bar code: SELECT FLASH ON TIME SETTING.5. Scan the appropriate two digits from the keypad in Appendix D, Keypad representing theduration which was determined in the steps above. You will hear a two-beep indicationafter the last character.If you make a mistake before the last character, scan the CANCEL bar codeto abort and not save the entry string. You can then start again at thebeginning.6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit ProgrammingMode.This completes the procedure. See Table 42 for examples of how to set this feature.Table 42. Flash On Time Setting ExamplesSTEP ACTION EXAMPLES1 Desired Setting 500ms 1,000ms (1 sec.) 5200ms (5.2 sec.) 9,900ms (9.9 sec.)2Divide by 100 (and pad withleading zeroes to yield twodigits)05 10 52 993 Scan ENTER/EXIT PROGRAMMING MODE4 Scan SELECT FLASH ON TIME SETTING5 Scan Two Characters FromAppendix D, Keypad ‘0’ and ‘5’ ‘1’ and ‘0’ ‘5’ and ‘2’ ‘9’ and ‘9’6 Scan ENTER/EXIT PROGRAMMING MODE