Product Reference Guide 791D SYMBOLOGIESThe reader supports the following 1D symbologies (bar code types). See "2D Symbologies" startingon page 169 for 2D bar codes. Symbology-dependent options are included in each chapter.D ISABLE ALL SYMBOLOGIES, page 80 , page 116CODE EAN/UPC, page 81 CODE ISBT 128, page 117, page 84 I NTERLEAVED 2 OF 5 (I 2 OF 5), page 120GTIN FORMATTING, page 87 I NTERLEAVED 2 OF 5 CIP HR, page 125EAN 13 (JAN 13), page 88 FOLLETT 2 OF 5, page 125, page 90 STANDARD 2 OF 5, page 126EAN 8 (JAN 8), page 91 I NDUSTRIAL 2 OF 5, page 130UPC/EAN G LOBAL S ETTINGS, page 93 CODE IATA, page 134ADD -O NS, page 95 CODABAR, page 135CODE 39, page 101 ABC CODABAR, page 141TRIOPTIC CODE, page 107 CODE 11, page 144CODE 32 (I TAL P HARMACEUTICAL CODE), page107GS1 DATA B AR™ O MNIDIRECTIONAL, page148CODE 39 CIP (FRENCH PHARMACEUTICAL ),page 109 GS1 DATA B AR™ E XPANDED, page 149CODE 39 D ANISH PPT, page 109 GS1 DATA B AR™ L IMITED, page 154CODE 39 L APOSTE, page 110 CODE 93, page 155CODE 39 PZN, page 110 , page 160CODE 128, page 111 PLESSEY, page 165Default settings are indicated at each feature/option with a green arrow. Also referenceAppendix C, Standard Defaults for a listing of the most widely used set of standard factory settings.To set most features:1. Scan the ENTER/EXIT PROGRAMMING bar code at the top of applicable program-ming pages.2. Scan the correct bar code to set the desired programming feature or parameter. You mayneed to cover unused bar codes on the page, and possibly the facing page, to ensure thatthe reader reads only the bar code you intend to scan.3. If additional input parameters are needed, go to Appendix D, Keypad, and scan the appropri-ate characters from the keypad.Additional information about many features can be found in the “Refer-ences” chapter.If you make a mistake before the last character, scan the CANCEL bar codeto abort and not save the entry string. You can then start again at thebeginning.4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAM-MING bar code to exit Programming Mode.GS1-128UPC-EISSNMSI
