Extended System-Level Command FunctionsClass Series Programmer’s Manual 103Sample: L1911A1802000010TEXTUXKtRUE00700ABCDEF1234H0000015001GThe sample creates a replaceable text field (01), recalls data from the RFID tag block zero (readingonly one block, which is attempted nine times), and prints the data in the location specified byreplaceable field.; Note: When using addressed commands and the tag with the specified UID cannot be found, a standardRFID read/write fault will be issued.STX KtU Read Unique Serial Number from RFID Tag(Direct Mode – HF [13.56 MHz] ISO15693 Tag Interface)This command instructs the RFID device to read the unique serial number data from the tag and thenplace that data into a replaceable field. It is expected that the tag transponder will be within the read /write distance of the RFID programming device; otherwise, “Void” will be printed in the text or barcode label field(s).; Note: This is a sixteen character alphanumeric value; the replaceable field must have an adequate length.Syntax: KtUabcca - The number of retry attempts, 0-9.b - Reserved. Should be 0.Where:cc - Field number in which to place the data (must be 01, 02, 03, etc.)matching the order of Label Formatting command, U.; Note: The 00 value will send the unique tag ID to the host with noprinting.
