System-Level Command FunctionsClass Series Programmer’s Manual 35STX Z Print Configuration LabelThis command causes the printer to produce a Database Configuration Label. To capture all printedinformation, use the labels as wide as the maximum print width (see Appendix K) and at least fourinches (102 mm) long.Syntax: ZPrinter response: FRI SEPTEMBER 026, 1997 19:29 244VER: E4304 - 04.06 08/24/01BOOT 83-2329-04ACODE 83-2325-04FFONT 83-2337-01ACPLD 59-2157-01CSYSTEM RAM CHECKS____ GOODSYSTEM RAM SIZE___ 2016 KBYTESSYSTEM RAM AVAIL__ 1264 KBYTESREG POWER SUPPLY__ NOINPUT VALUESPAPER_____________ 255DARKNESS__________ 131TRAN______________ 255REFL______________ 149RIBM______________ 87THR_______________ 4824V_______________ 223DIRECT THERMALCOMMUNICATIONS NOT DETECTED9600,8,NEDGESOP ADJUST________ 128PRESENT ADJUST____ 128TOF LOW___________ 0TOF DELTA_________ 10TOF GAIN__________ 10OOS MAXVOLT_______ 2COUNTER INFORMATIONABSOLUTE VALUES 9-18-1999LENGTH____ 773 INCHESTIME______ 20 HOURSRESETTABLE VALUES 9-22-1999LENGTH____ 576 INCHESTIME______ 10 HOURSMEMORY CONFIGURATIONINTERNAL MODULE______ 128SCALABLE FONTS_______ 64LABEL SIZE 0410:02218 IN; Note: Printed information will vary according to printer, model, firmware version, and options.STX z Pack ModuleThis command causes the printer to reclaim all storage space associated with all deleted files on thespecified module (see X and x).Syntax: zmWhere: m - The module identification character, see Appendix K.
