RS20i Installation and Operating Guide Page 64RS20i Installation & Operating Guide Document # 9301H52900 Ver. 1.02Function DescriptionPink Noise MultiChanEnabling allows multiple channels of pink noise to be chosen. When multi-channel pink noise is disabled, selecting pink noise on one channelautomatically disables pink noise from the other channels.Digital VolumeEnableWhen the Digital Volume is not Enabled, the master volume control will have noeffect on the volume of the Digital Output. Once Digital Volume is Enabled, theDigital Volume Offset, which may be set from -70.0 dB to 0.0 dB, should be setto the volume control level that is considered maximum. For example, if theDigital Volume Offset is set to -15dB, then the digital signal attenuates asexpected when the master volume control is set below -15dB. The digital signalvolume will not increase if the volume control goes above the Digital VolumeOffset.Digital VolumedB OffsetAdjust by selecting it and using the Volume Control knob. The volume level isin effect only if the enable/disable box is enabled (blue).Note: The Pink Noise and Mute settings are temporary and not saved with theconfiguration.Note: Channels 1 through 16 on this screen refer to the input channels. In caseswhere the input is routed to a different output channel, the control representsonly the input channel path. The same is true if the channel is routed to morethan one output in a crossover configuration. For example, if L (Ch1) is routedto output channels 1 (Left-H) and 2 (Left-L), then if Ch1 is inverted the signalwill be inverted on both output channels 1 and 2.4.5 Output PresetThe Output Preset screen allows you to select and/or configure the Output Preset for the current InputPreset.To access Output Preset Setup: