RS20i Installation and Operating Guide Page 73RS20i Installation & Operating Guide Document # 9301H52900 Ver. 1.02Table 25. Speaker FilterControl DescriptionChan nn-+Channel selection- previous channel+ next channelPink Noise On/Off Channel pink noise.FiltersEnabled/Disabled Enable or Disable all PEQ filters for all channels.Constant Q/BW Constant Q or constant bandwidth.Filter 1-9 Select filter 1 to 9 to set the filter parameters.Freq (Hz) Filter Frequency: 20Hz to 20kHz.Q Filter Q: 0.1 to 10.0.Gain Filter Gain: -60dB to 12.0dB.4.6 Bass Management SetupThis section describes how to configure the bass management on the RS20i using the Setup screens.This assumes that you are familiar with the RS20i bass management features and concepts. If not, youare encouraged to review topic 4.7.3, Bass Management Theory (page 83) before proceeding with thesetup.The Bass Management configuration, including the Speaker Configuration, is contained within an OutputPreset configuration of the RS20i. The configuration changes made in this screen are applied to thecurrently selected Output Preset. Separate Output Presets can be made with different Bass Managementand Speaker Configuration settings.Bass management balances the bass portion of the audio system based on the speaker configuration.Sub-bass configurations vary from none up to 4 subwoofers.
