Entering the Setup ProgramThere are two ways to enter the setup program: by pressing orby pressing .1. Pressing to Enter the Setup ProgramYou will need to press , to enter the setup program in the followingsituations:Ž when your computer is turned on for the first timeŽ when the rechargeable battery is deadŽ when the hardware configuration is changedIf the battery for CMOS chip is dead or the system configuration doesnot match your actual hardware configuration, you will have to recon-figure your system. The computer will give you this screen message:Press the F1 key to enter the setup program orp r e s s a n y o t h e r k e y t o c o n t i n u eUnder the above three conditions, pressing will automaticallystart the setup program.Under any conditions within DOS, you can use the DOS DEBUGcommand as follows:A> DEBUG 8-g=F000:FF60 8This command will start the setup program.12 Chapter 3: Operating Your System
