Daum electronic ergo_run classic User Manual
                                      | |
Contents
| 
7D2 4Installing the deviceThe ergometer should be installed on a rigid floor (e.g. concrete floor).For other types of floor we recommend using a protective underlay. Ap-propriate floor protection mats can be ordered from daum electronicgmbh. The manufacturer shall not be liable for any damage done to thefloor. Order No.: 0810402To ensure the safety of the user you must leave a safety clearance area, ofat least 2 m in length and 1 m in width, behind the treadmill. In order to avoidinjuries this safety clearance area should be covered by a soft exercise mat orany similar furniture. The location of the device must be level (flat) and clean.The device must be installed in a horizontal position and may not “wobble”.The feet must be adjusted accordingly and must absolutely have a steadycontact with the floor.It is not intended for use in rooms with damp conditions. This could cause rustto build up on the ergo_run, which would damage device parts and impair boththe operating functions and the safety features.The load carrying capacity of the ceiling / floor in the building must at least beequal to 600 kg / square meter. If in doubt consult a building stress analyst.The tension of the running belt must be checked upon installation or wheneverthe device is moved from one location to another, and adjusted as needed(see the maintenance chapter).The treadmill may only be connected to the power supply and put into opera-tion when the above conditions are satisfied; connect it by plugging its powercable to an appropriate power socket (see connecting the device).The ergo_run functions with a mains voltage of 230 Volt, 50 Hz and has apower consumption of 2000 Watt. The power supply you wish to use mustsatisfy these requirements!Before proceeding with the assembly please make sure thatthe mains plug is pulled out!Transport and packagingThe manufacturer and the dealer will not be held liable fordamages occurring during the transport and for missingparts.Therefore please check the packaging and its content ca-refully upon receiving of the device. Complaints related totransport damages will only be accepted by the transportinsurance if they are immediately recorded by writing on thedelivery documents of the freight forwarder.Please address any complaints to daum electronic gmbh.In general daum training devices are delivered by a forwarding company.Daum electronic gmbh is a member of the organisation: “Der grüne Punkt –Duales System Deutschland GmbH.”Please proceed with the unpacking of the device and accessories as descri-bed in the user manual. Please make sure that the device and accessoriesare not damaged, that small parts are not inadvertently misplaced, and thatconnection cables are not damaged.Please dispose of all packaging material in a safe way. Keep all foil and plasticbags away from children- suffocation risk.If in doubt, ask another person to help you with the installation.Heavy equipments may only be transported by authorisedpersonnel and under compliance with the relevant safetyregulations. Otherwise a serious risk exists for the personsand machine.!!!3Installing the deviceRelease the immobilising belt.1Release the cable tie.Open the bottom box.Pull/raise the device carefully.3.1Moving the device: attach the belt, lift the rear ofthe device and move it on its wheels.Installing and starting GB |
Related manuals for Daum electronic ergo_run classic
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine