DeLonghi ECAM37X.95 Instructions For Use Manual

Also see for DINAMICA PLUS: Quick start guide Quick start guide Instructions for use Manual User manual

15To remove the drip tray, proceed as follows:1. Remove the drip tray and coffee grounds container (A11)(fig. 22);2. Remove the cup tray (A12) and drip tray grille (A14), thenempty the drip tray and grounds container and wash allcomponents.3. Check the condensate tray (A15) (red) and empty ifnecessary;4. Put the drip tray complete with grille and grounds contain-er back in the appliance.13.5 Cleaning the inside of the coffee machineDanger of electric shock!Before cleaning internal parts, the machine must be turned off(see section "5. Turning the appliance off") and unplugged fromthe mains power supply. Never immerse the machine in water.1. Check regularly (about once a month) that the inside of theappliance (accessible after removing the drip tray (A15))is not dirty. If necessary, remove coffee deposits with thebrush (D5) supplied and a sponge.2. Remove all residues with a vacuum cleaner (fig. 24).13.6 Cleaning the water tank1. Clean the water tank (A17) regularly (about once a month)and whenever the water softener filter (D7) (if installed) isreplaced with a damp cloth and a little mild washing up liq-uid. Rinse thoroughly before filling the tank and putting itback in the appliance;2. Remove the filter (if installed) and rinse with runningwater;3. Replace the filter (if installed), fill the tank with fresh waterand replace;4. (Models with water softener filter only) Deliver about100ml of hot water to reactivate the filter.13.7 Cleaning the coffee spouts1. Clean the coffee spouts (A9) regularly with a sponge orcloth (fig. 25A);2. Check the holes in the coffee spouts are not blocked. If nec-essary, remove coffee deposits with a toothpick (fig. 25B).13.8 Cleaning the pre-ground coffee funnelCheck regularly (about once a month) that the pre-groundcoffee funnel (A4) is not blocked. If necessary, remove coffeedeposits with the brush (D5) supplied.13.9 Cleaning the infuserThe infuser (A20) must be cleaned at least once a month.Important!The infuser cannot be removed when the machine is on.1. Make sure the machine is correctly turned off (see section"5. Turning the appliance off");2. Remove the water tank (A17) (fig. 3);3. Open the infuser door (A19) (fig. 26) on the right side ofthe appliance;4. Press the two coloured release buttons inwards and at thesame time pull the infuser outwards (fig. 27);5. Soak the infuser in water for about 5 minutes, then rinseunder the tap;Important!RINSE WITH WATER ONLYNO WASHING UP LIQUID - NO DISH WASHERClean the infuser without using washing up liquid as it couldbe damaged.6. Use the brush (D5) to remove any coffee residues left in theinfuser housing, visible through the infuser door;7. After cleaning, replace the infuser by sliding it onto theinternal support (fig. 28), then push the PUSH symbol fullyin until it clicks into place;Please note!If the infuser is difficult to insert, before insertion, adapt it to theright size by pressing the two levers shown in fig. 29.8. Once inserted, make sure the two coloured buttons havesnapped out (fig. 30);9. Close the infuser door;10. Put the water tank back.13.10 Cleaning the milk containerTo keep the frother efficient, clean the milk container every twodays as described below.1. Remove the lid (E2);2. Remove the milk spout (E5) and intake tube (E4) (fig. 31);3. Turn the froth adjustment dial (E1) anticlockwise to the"INSERT" position (fig. 31) and pull it off upwards;4. Wash all the componentsthoroughly with hotwater and mild wash-ing-up liquid. All com-ponents are dishwash-er safe, but must beplaced in the top bas-ket of the dishwasher.Make sure there are nomilk residues on the hol-low and groove under thedial (fig. 32). If necessary,scrape the groove with atoothpick;5. Rinse inside the froth adjustment dial seat with runningwater (fig. 33);33