If the Left Face Plate (M7082A) has been disassembled refer to the following instructions. Replacethe Wire Cutter Slide (M7107A) in the Left Face Plate and replace the Wire Cutter Operating SlideWedge (7105) in its groove in the Face Plate Engage the Wire Cutter Operating Slide Shoe (7104)with the Wire Cutters (7102) in the Wire Cutter Holder (7103A). Slide the Wire Cutter Holder intothe groove in the Left Face Plate, making sure to line up the Shoe with the Shoe Wedge. (Sometimesit helps to turn the whole Left Face Plate Assembly upside down and allow gravity to hold the ShoeWedge in place.) Turn the machine over manually until the Slider (66) and the Drive Link (G30096)are in their up-most position. Adjust the Hand Wheel (G30128) until there is a 1/4" space between theAdjuster Spool (G30119) and the lower Adjuster Stop (G30103). Attach the assembled Left Face Plateto the Head Mounting Plate (G30092) with the Upper (7084) and Lower (7085) Face Plate Screws.Install the upper Adjuster Rack (G30091) in the notch of the Wire Cutter Holder and over the two (2)Swivel Operating Sector Pins (7161). Replace the Wire Feed Adjustment Pinion (7114) between thetwo (2) Adjuster Racks. The Pinion should fit snugly but not have to be forced. If the Pinion does notfit without force, remove the lower Adjuster Rack (G30090) and replace it after putting the Pinion intoplace. Replace the AdjusterRack Cover Plate (G30093) andthe Face Plate Hinge Mount(G30123) and secure themwith two (2) Screws (P3255).Make sure that the Wire CutterSlide Friction Spring (7205)and Friction Plug (7204) arein position before securingthe Latch Mount to the LeftFace Plate. Tighten the Screw(38) and back off 1/2 of aturn. While the Screws arebeing tightened press the LatchMount toward the front of thestitcher machine.If the Left Face Plate wasnot disassembled, begin reas-sembly as follows: Replace theSupporter Crank Links (7101)and the Supporter Assembly(7100A) on the stitcher andReassembly (Figures 25 & 26)32Do not operate the M7 under power until themachine has been turned over manually to verifythat the stitching head is operating freely.WARNING!Figure 25 - Re-Assembling the HeadM7082AM7107A710571047103AG3009270847085G300917161 (2)7114G30093P3255 (2)G301237101 (2)7100A7241711438