Dedicated Micros Dennard 2040 Menu System Manual

Also see for 2060: Operation manual Operation manual Quick start guide Installation manual System manual

Dedicated Micros Dennard 2040 Menu System Manual Manual pdf 12 page image

4. OPERATION WITH A CONTROL PANELNB: This will vary between control panels. Please refer to the Controller manual.The Dome Camera's are open protocol devices. Consequently, there are several differentmanufacturers’ controllers available to drive it. All of the many features offered by the dome areprogrammed from one of three menu structures. Each controller will have individual controlconfigurations which make it essential that the user reads the controller manual to ascertain whichbutton activation gives access to the menu features. Section 6 gives these functions for severalpopular controllers.The following instructions will guide you through the menu structure when using the Dome & PSU(with address set to No. 253… DEN PANEL) controlled by either a Dennard dtx400dc or dtx1000dc4.1 Dome Menu Structure with Dennard controllersThe Menus appear on the screen when activated by the following commands:Note that the ‘shift’ key must be held down while the selection is made.On activation, the menu will appear on the monitor screen against the normal video scenebackground with a cursor on the left hand edge. A choice is made by positioning the cursor over thedesired feature and operating an “ACCEPT” button(s) which, for the Dennard controllers, is asfollows:-For Dennard dtx1000dc, hold the preset button and press CAMERA SELECT 1For Dennard dtx 400dc, press preset 1 buttonDennard 2040 / 2060 Menu System Manual Page. 10Dennard dtx1000dcaccessDennard dtx400dcaccessUser Menu shift wash shift 1Supervisor Menu (password required) shift wipe shift 2Technicians Menu (password required) shift autopan shift 3