DOME PROGRAMMING:To access the domes menus, there are two possibilities:1. For systems set up for 485 control or with Sprite systems dating from mid-2004 onwards,configured for Dennard C coax control, press the * key twice and a message will appearon the screen saying, “To enter the menu press enter button”.2. For older systems using coax control, the following key presses are used:For the Operator menu press: * 8 8 9 10 10 2For the Supervisor menu press: * 8 8 9 10 10 3For the Technician menu press: * 8 8 9 10 10 4The Operator menu will then be displayed enabling you to navigate around the menus using thejoystick to move the cursor and pressing the ‘enter’ key to accept menu options.6.1.2 RS485 controlThe controller telemetry must be configured as follows:-Dennard Serial telemetry. This is set up in the System Options menu of the Sprite 2 and thenselected in the Alarms and Presets menu.Each Dome must be individually addressed(Refer to the Operation/Installation Manual, supplied with each Dome, for an explanation on accessto, and setting of, the address switches)RS485 connection from the Sprite 2 is via a 9-way D type female connector and the connection isas follows: pin 1 = data A =yellow wire from domepin 9 = data B =green wire from domeDomes are, by default, supplied with termination resistors fitted. These will need to be removedfrom all but the last dome in the Daisy chain.6.2 Baxall / Vista controllersUp the coax controlThe controller telemetry must be configured as follows:-1: Rx attached, needs to be set to DC2: Telemetry mode, needs to be set to STANDARDThe Dome address switches need to be set to BAX DC PANEL(Refer to the Operation/Installation Manual, supplied with each Dome, for an explanation on accessto, and setting of, the address switches)Blue rotary address switch set to F…. Yellow rotary address switch set to E.Dennard 2040 / 2060 Menu System Manual Page. 32