Dedicated Micros Eco4 Installation & Operation Manual

Also see for Eco4 Series: Quick start guide

Contents

Dedicated Micros Eco4 Installation & Operation Manual Manual pdf 8 page image

Dedicated Micros ©2011MI-I-ECO4/E1-28 Eco4Installing the UnitBefore you startCheck the contents of the boxThe following items are included in the box:Remove all items from the packaging and check the items listed below are present.• Eco4 DVR• 12v DC Power Adaptor• USB Mouse• Eco4 Software CD• Quick Start GuideIf any of these items are missing please contact Dedicated Micros Technical Support team.IMPORTANT: An IR Remote Control (DM/RC06) can be purchased separately, contact yourregional Dedicated Micros representative for further details.Note: Before installing the unit, carefully read all Safety Instructions and the following information onwhere the unit should be located.Choosing a location for installation• The unit is designed to be desk or shelf mounted.• Ensure the unit is properly ventilated to protect from overheating.• Ensure there is a 3cm gap on both sides of the unit.• Ensure the unit is not located anywhere it could be subject to mechanical shocks.• The unit should be located in an area with low humidity and a minimum of dust. Avoidplaces like damp basements or loft spaces.• If the unit is to be installed in a closed assembly, the maximum operating temperaturemust not exceed 40°C (104°F).• Ensure there is reliable earthing of the mains outlet when fitted to supply connections(other than direct connection to the branch circuit).• It is recommended that an uninteruptable power source be connected to the unit incase of power failure (to ensure continuous operation of the unit).Electrical ConnectionsPlease ensure the following are available and have been tested prior to the installation:• Mains point• Network point• Network cable• Active video signals i.e. at least one working camera feed• PC with CD ROM drive and connection to the same network as the DVR(Recommended).Intelligent Security & Fire Ltd