Operator Panel 77Printing a Device Settings PagePress and hold the ( Start) button when the Ready/Data indicator lights(ready status) until the Ready/Data indicator blinks.Resetting DefaultsAfter executing this function and rebooting the printer, all the menuparameters are reset to their default values.1 Turn off the printer.2 Open the rear cover.3 While holding down the (Start) and the (Cancel) buttons at thesame time, turn on the printer.4 After the Orange LED on the Ready/Data indicators go out, release the(Start) and (Cancel) buttons.5 Close the rear cover.• Initializes the non-volatile memory (NVM).CAUTION: Never attempt to turn off the printer. The printer will cease tofunction.The printer restarts automatically to apply the settings and prints theprinter settings and device settings pages.6 Check if the factory settings are restored by referring to the PrinterSettings and Device Settings pages.- - - An error occurred whiledownloading the firmware.Turn off the printer, and thenon.1 2 3 4 5 7 8 Cause/RemedyJam Toner Error Ready/DataStart ManualDuplexLoadPaperY M C K
