12Pr eparing Your Multi-Function Printerw w w . d e l l . c o m / s u p p l i e s|s u p p o r t . d e l l . c o m3Connect one end of the multi-function printer power cord into the socket at the backof the multi-function printer andthe other end into a properly grounded outlet.4Power on the multi-function printer.After the multi-function printer completes its internal tests, the operator panel reportsa “READY” stats.If the operator panel does not show a “READY” state when the multi-function printeris powered on, make sure the power cord is firmly plugged in to the back of themulti-function printer and the electrical outlet.If the multi-function printer is on but does not print, power off the multi-functionprinter and wait 30 seconds. Power on the multi-function printer again, and it shouldreset and return to a “READY” state.Print and Check the Network Set-Up Page1When the operator panel displays “READY”, press NetworkSetup” appears.2Press the scroll button (or) to display “PrintSys.Date” on the bottom lineand press If Status is Not Connected:–Make sure the Ethernet cable is firmly plugged into the back of the multi-functionprinter.–Plug the Ethernet cable into another wall outlet.3Under the “TCP/IP” heading on the network setup page, make sure the IP address,netmask, and gateway are what you expected.
