Contents - Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Figure A-1. Main Menu
- orientation ,
- front/right side internal view ,
- Figure 1-4. Back/Left Side Internal View
- socket population rules ,
- SCSI configuration guidelines ,
- SCSI ID numbers ,
- externally-accessible drive bays ,
- power supply ,
- Figure 1-6. DC Power Connector P1
- cables ,
- Figure 1-10. DC Power Distribution
- Figure 1-11. System Board Components
- Figure 1-12. System Board Jumpers
- Table 1-2. Jumper Descriptions
- Table 1-3. Interrupt Assignments
- Table 1-4. DREQ Line Assignments
- technical specifications ,
- diskette-based diagnostics ,
- beep codes ,
- Table 3-1. POST Beep Codes
- Table 3-2. System Error Messages
- precautionary measures ,
- cover removal ,
- bezel, removal ,
- insert removal ,
- removal ,
- Figure 4-5. Drive Hardware
- externally-accessible drives, removal ,
- Figure 4-7. Drive-Mounting Rails and Extensions Removal
- Figure 4-8. Hard-Disk Drive Removal
- expansion-cards, removal ,
- Figure 4-10. Power Supply Removal
- system cooling fan, removal ,
- Figure 4-12. System Board Components
- installation ,
- Figure 4-15. Microprocessor Securing Clip Removal
- Figure 4-16. Microprocessor/Heat Sink Assembly
- battery, removal ,
- Figure 4-18. System Board Assembly Removal
- Figure 4-19. System Board Removal
|
Beep Codes and Error Messages 3-1Chapter 3Beep Codes and Error MessagesThis chapter describes beep codes and system error messages that can occurduring POST or, in the case of some failures, during normal system operation.The tables in this chapter list faults that can cause a beep code or system errormessage to occur and the probable causes of the fault in each case.If a faulty system does not emit beep codes or display system error messages toindicate a failure, you should use the diskette-based diagnostics to run theappropriate tests to help isolate the source of the problem. See “Running theDiskette-Based Diagnostics” in Chapter 2.POST Beep CodesIf the monitor cannot display error messages during the POST, the system mayemit a series of beeps that identifies the problem or that can help you identify afaulty component or assembly. Table 3-1 lists the beep codes that may be gener-ated during the POST. Most beep codes indicate a fatal error that prevents thesystem from completing the boot routine until the indicated condition iscorrected.When the system emits a beep code, record the code and then find it inTable 3-1. If the table does not lead to the source of the problem, run the appro-priate tests in the diskette-based diagnostics to assist in troubleshooting theproblem.Table 3-1. POST Beep CodesBeep Code Error Probable Causes1-2 Invalid Expansion-card-ROM checksumImproperly seated expan-sion card or the systemneeds rebooted.1-2-2-3 Invalid BIOS ROMchecksumCorrupted BIOS firmwareor defective system board.1-3-1-1 DRAM refresh failure Defective DIMMs or sys-tem board. Reseat theDIMMs or replace the sys-tem board. PreviousNext |