Contents - Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Figure A-1. Main Menu
- orientation ,
- front/right side internal view ,
- Figure 1-4. Back/Left Side Internal View
- socket population rules ,
- SCSI configuration guidelines ,
- SCSI ID numbers ,
- externally-accessible drive bays ,
- power supply ,
- Figure 1-6. DC Power Connector P1
- cables ,
- Figure 1-10. DC Power Distribution
- Figure 1-11. System Board Components
- Figure 1-12. System Board Jumpers
- Table 1-2. Jumper Descriptions
- Table 1-3. Interrupt Assignments
- Table 1-4. DREQ Line Assignments
- technical specifications ,
- diskette-based diagnostics ,
- beep codes ,
- Table 3-1. POST Beep Codes
- Table 3-2. System Error Messages
- precautionary measures ,
- cover removal ,
- bezel, removal ,
- insert removal ,
- removal ,
- Figure 4-5. Drive Hardware
- externally-accessible drives, removal ,
- Figure 4-7. Drive-Mounting Rails and Extensions Removal
- Figure 4-8. Hard-Disk Drive Removal
- expansion-cards, removal ,
- Figure 4-10. Power Supply Removal
- system cooling fan, removal ,
- Figure 4-12. System Board Components
- installation ,
- Figure 4-15. Microprocessor Securing Clip Removal
- Figure 4-16. Microprocessor/Heat Sink Assembly
- battery, removal ,
- Figure 4-18. System Board Assembly Removal
- Figure 4-19. System Board Removal
| 
4-12 Dell PowerEdge 2100/180 and 2100/200 Systems Service ManualS ystem Power SupplyFigure 4-10. Power Supply RemovalTo remove the system power supply, follow these steps:1. Disconnect the AC power cable from the AC power connector on theback of the power supply.2. Disconnect the DC power cables from the system board (seeFigure 4-12), the externally accessible drives, and the hard-disk drives(see Figure 4-5).Be sure to record the connector number and plug location for each powercable.3. Remove the four power-supply mounting screws.4. Slide the power supply forward about an inch to clear the retainingtabs, then lift it out of the computer.When you reinstall the power supply, be sure the slots on the bottom of thepower supply engage the retaining tabs on the computer chassis.AC power connectorpower supplypower-supplymounting screws (4) |
