Load the recommended print side correctly for the type of print mediayou are using. See "Loading Print Media in Standard and Optional Trays"for more information.Turn the print media over or around and try printing again to see iffeeding improves.Do not mix print media types.Do not mix reams of print media.Remove the top and bottom sheets of a ream before loading the printmedia.Load a print media source only when it is empty.Wipe the feeder rollers in the trays or multipurpose feeder with a cloththat slightly dampened with water.Envelope misfeeds or multiplefeeds occur.Reduce the number of envelopes in the stack.Page breaks in unexpectedplaces.Check the Time-Out in the System Settings menu. Increase the setting.Job prints from the wrongsource or on the wrong printmedia.Check the Paper Type in the Tray Settings menu on the printeroperator panel and in the printer driver.Print media does not stackneatly in the output bin.Turn the print media stack over in the tray or multipurpose feeder.Printer does not duplex pages. Make sure 2 Sided is selected in both the PCL (Printer ControlLanguage) menu on the printer operator panel and in the printer driver.Make sure you have enough print memory installed.Print Quality ProblemsProblem ActionPrint is too light. · The print cartridges may be low or need to be replaced. Confirm the amountof toner in each print cartridge and replace it with a new one if necessary.· Set the Toner Saving Mode check box to off in the Advanced tab in theprinter driver.· If you are printing on an uneven print surface, change the Paper Typesettings in the Tray Settings menu. See "System Settings."· Verify that the correct print media is being used.
