Adding and Replacing Parts 109NOTICE: To help prevent damage to the system board, you must remove the batteryfrom the battery bay before you service the computer.NOTE: To avoid damage to the computer, use only the battery designed for thisparticular Dell computer. Do not use batteries designed for other Dell computers.5 Turn the computer over.6 Slide the battery release latch toward the side of the computer until itis engaged.7 Slide the battery out of the battery bay.8 Turn the computer top-side up, open the display, and press the powerbutton to ground the system board.9 Remove any installed cards from the ExpressCard slot (see "Removing anExpressCard or Blank" on page 63) and the 8-in-1 memory card reader (see"Removing a Memory Card or Blank" on page 65).Hard DriveCAUTION: If you remove the hard drive from the computer when the drive is hot,do not touch the metal housing of the hard drive.CAUTION: Before you begin any of the procedures in this section, follow thesafety instructions in the Product Information Guide.1 battery 2 battery release latch21Downloaded from www.Manualslib.com manuals search engine
