Driver Installation 755 Select [3] if you created a diskette from the mega_sas.img file and you areusing a removable (USB) diskette drive.6 Follow instructions presented by Driver Update installer.7 The following message displays: Installation of was successful.8 Select [e] to end9 Follow the instructions on the screen to complete installation.Adding/Updating the Driver to an Existing System1 To add the mega_sas driver to an existing system, or to upgrade to a newerversion of the driver, you must unarchive the driver package and executethe installation script:tar xvf x86_64.tarcd x86_64./install.sh2 Restart your Solaris system to start using the new driver. To confirm themega_sas driver is loaded, run the following command:modinfo | grep mega_sas3 Ensure that the driver version is correct.Installing NetWare DriversUse the procedures in this section to install the driver for Novell NetWare 6.5.To ensure that you have the current version of the driver, download theupdated NetWare driver from the Dell Support website at support.dell.com.Installing the NetWare Driver in a New NetWare SystemFollow the instructions in the Novell NetWare Installation Guide to installNovell NetWare in the system. Perform the following steps to install NovellNetWare using the SAS RAID controller as a primary adapter:1 Boot from the Novell NetWare media.2 Follow the instructions on the screen until you reach the Device Driver screen.3 Select Modify, and press .
