Wireless network setupThe window showing the wireless network settings appears. Check the When the window that tells you that the network cable connection is12 13settings and click Next. confirmed appears, disconnect the network cable and click Next.If the network cable is connected, it may have trouble finding themachine when configuring the wireless network.Before entering the IP address for the machine, you must know thecomputer’s network configuration information. If the computer’s networkconfiguration is set to DHCP, the wireless network setting should also be 14 The wireless network connects according to the network configuration.DHCP. Likewise, if the computer’s network configuration is set to Static, thewireless network setting should also be Static. Wireless network set up is completed. After installation is finished, click15 Quit.If your computer is set to DHCP and you want to use Static wireless networksetting, you must contact the network administrator to get the static IPaddress. After completing the wireless network connection, you need to install a• For the DHCP method machine driver to print from an application (see "Installation for Mac" onIf the IP address assignment method is DHCP, check if DHCP is shown in page 98).the Wireless Network Setting Confirm window. If it shows Static, clickChange TCP/IP to change the assignment method to Receive IPaddress automatically (DHCP).• For the Static methodIf the IP address assignment method is Static, check if Static is shown inthe Wireless Network Setting Confirm window. If it shows DHCP, clickChange TCP/IP to enter the IP address and other network configurationvalues for the machine.For example,If the computer’s network information is shown as follows:- IP address: 169.254.133.42- Subnet Mask: 255.255.0.0Then, the machine’s network information should be as shown below:- IP address: 169.254.133.43- Subnet Mask: 255.255.0.0 (Use the computer’s subnet mask.)- Gateway: 169.254.133.12. Using a Network-Connected Machine 130
