Universal Setup menuUse ToUnits of MeasureInchesMillimetersIdentify the units of measure.Notes:• Inches is the US factory default setting.• Millimeters is the international factory default setting.Portrait Width3–8.5 inches76–216 mmSet the portrait width.Notes:• If the width exceeds the maximum, then the printer uses themaximum width allowed.• 8.5 inches is the US factory default setting. You can increase thewidth in 0.01‑inch increments.• 216 mm is the international factory default setting. You can increasethe width in 1‑mm increments.Portrait Height3–14.17 inches76–360 mmSet the portrait height.Notes:• If the height exceeds the maximum, then the printer uses themaximum height allowed.• 14 inches is the US factory default setting. You can increase theheight in 0.01‑inch increments.• 356 mm is the international factory default setting. You can increasethe height in 1‑mm increments.Feed DirectionShort EdgeLong EdgeSpecify the feed direction if the paper can be loaded in either direction.Notes:• Short Edge is the factory default setting.• Long Edge appears only when the longest edge is shorter than themaximum width supported in the tray.Reports menuReports menuUse ToMenu Settings Page Print a report containing information about the paper loaded in trays, installedmemory, total page count, alarms, timeouts, printer control panel language,TCP/IP address, status of supplies, status of the network connection, and otherinformation.Device Statistics Print a report containing printer statistics, such as supply information and detailsabout printed pages.Understanding the printer menus 61
