102 Removing and Installing Partsw w w . d e l l . c o m | s u p p o r t . d e l l . c o m 4 Connect the other end of the data cable to the connector labeled FLOPPY on the systemboard (see page 75).5 If you are installing a new floppy drive rather than replacing a drive, remove the front-panelinserts (see page 98).6 Check all cable connections, and fold cables out of the way to provide airflow for the fan andcooling vents.7 Close the computer cover. (see page 107).NOTICE: To connect a network cable, first plug the cable in to the network device and then plug it in tothe computer.8 Connect your computer and devices to their electrical outlets, and turn them on.See the documentation that came with the drive for instructions on installing any softwarerequired for drive operation.9 Enter system setup (see page 113) and select the appropriate Diskette Drive option.10 Verify that your computer works correctly by running the Dell Diagnostics (see page 55).CD/DVD DriveCAUTION: Before you begin any of the procedures in this section, follow the safety instructionslocated in the Product Information Guide.CAUTION: To guard against electrical shock, always unplug your computer from the electrical outletbefore opening the cover.Removing a CD/DVD Drive1 Follow the procedures in "Before You Begin" on page 63.2 Disconnect the power and data cables from the back of the drive.
