General Memory Module Installation GuidelinesThis system supports Flexible Memory Configuration, enabling the system to be configured and run in any valid chipsetarchitectural configuration. The following are the recommended guidelines for best performance:• x4 and x8 DRAM based DIMMs can be mixed. For more information, see Mode-Specific Guidelines.• Up to two quad-rank RDIMMs and up to three dual- or single-rank RDIMMs can be populated per channel.When a quad-rank RDIMM is populated in the first slot with white release levers, the third DIMM slot in thechannel with green release levers cannot be populated.• Populate DIMM sockets only if a processor is installed. For single-processor systems, sockets A1 to A12 areavailable. For dual-processor systems, sockets A1 to A12 and sockets B1 to B12 are available.• Populate all sockets with white release tabs first, then black, and then green.• Do not populate the third DIMM socket in a channel with green release tabs, if a quad-rank RDIMM is populatedin the first socket with white release tabs.• Populate the sockets by highest rank count in the following order — first in sockets with white release levers,then black, and then green. For example, if you want to mix quad-rank and dual-rank DIMMs, populate quad-rank DIMMs in the sockets with white release tabs and dual-rank DIMMs in the sockets with black release tabs.• In a dual-processor configuration, the memory configuration for each processor should be identical. Forexample, if you populate socket A1 for processor 1, then populate socket B1 for processor 2, and so on.• Memory modules of different sizes can be mixed provided that other memory population rules are followed (forexample, 2 GB and 4 GB memory modules can be mixed).• Populate four DIMMs per processor (one DIMM per channel) at a time to maximize performance.• If memory modules with different speeds are installed, they will operate at the speed of the slowest installedmemory module(s) or slower depending on system DIMM configuration.Mode-Specific GuidelinesFour memory channels are allocated to each processor. The allowable configurations depend on the memory modeselected.NOTE: x4 and x8 DRAM based DIMMs can be mixed providing support for RAS features. However, all guidelines forspecific RAS features must be followed. x4 DRAM based DIMMs retain Single Device Data Correction (SDDC) inmemory optimized (independent channel) mode. x8 DRAM based DIMMs require Advanced ECC mode to gainSDDC.The following sections provide additional slot population guidelines for each mode.Advanced ECC (Lockstep)Advanced ECC mode extends SDDC from x4 DRAM based DIMMs to both x4 and x8 DRAMs. This protects against singleDRAM chip failures during normal operation.Memory installation guidelines:• Memory modules must be identical in size, speed, and technology.• DIMMs installed in memory sockets with white release tabs must be identical and similar rule applies forsockets with black and green release tabs. This ensures that identical DIMMs are installed in matched pairs -for example, A1 with A2, A3 with A4, A5 with A6, and so on.NOTE: Advanced ECC with Mirroring is not supported.36