Item Connector Description45 J_BP_SIG0 Backplane signal connector 0Disabling A Forgotten PasswordThe system's software security features include a system password and a setup password. The password jumperenables these password features or disables them and clears any password(s) currently in use.CAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.2. Open the system.3. Move the jumper on the system-board jumper from pins 4 and 6 to pins 2 and 4.4. Close the system.The existing passwords are not disabled (erased) until the system boots with the Jumper on pins 2 and 4. However,before you assign a new system and/or setup password, you must move the jumper back to pins 4 and 6.NOTE: If you assign a new system and/or setup password with the jumper on pins 2 and 4, the system disablesthe new password(s) the next time it boots.5. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.6. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.7. Open the system.8. Move the jumper on the system-board jumper from pins 2 and 4 to pins 4 and 6.9. Close the system.10. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.11. Assign a new system and/or setup password.98
