Peripheral Configuration SubmenuIDE Configuration SubmenuEvent LogConfigurationDisplays the Event Log Configuration submenu.Option FunctionUSB Controller Sets the USB controller to either Enabled (default) or Disabled.Legacy USB Support Set to Disabled if legacy USB support is not desired. Enabled (default) allows support for legacy USB.Integrated Audio Sets the integrated audio controller to either Enabled (default) or Disabled.Integrated Network Adapter Sets the integrated network controller to either Enabled (default) or Disabled.Serial Port Sets the integrated serial port setting to Auto, (default) 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, 3F8/IRQ4, or Disabled.Parallel Port Sets the integrated parallel port setting to Auto, (default) 3BC/IRQ7, 278/IRQ5, 378/IRQ7, or Disabled.Parallel Port Mode Sets the integrated parallel port mode to Bi-directional (default), Output Only, ECP, or EPP.ECP Mode Use DMA If the Parallel Port Mode option is set to ECP, this setting selects the ECP DMA mode. The options are 3 (default) and 1.Option FunctionPrimary IDEControllerConfigures the integrated primary IDE controller as either Enabled (default) or Disabled.Secondary IDEControllerConfigures the integrated secondary IDE controller as either Enabled (default) or Disabled.IDE Drive UDMA Set IDE Drive UDMA mode as either Enabled (default) or Disabled.IDE Primary Master Identifies the first drive attached to the primary IDE interface, usually the boot hard drive. See "IDE Primary Master Submenu."