Dell Dimension 3000 Owner's Manual

Also see for Latitude 3000 Series: Installation instructions Service manual Setup and specifications Manual Service manual

Contents

Dell Dimension 3000 Owner's Manual Manual pdf 71 page image

Removing and Installing Parts 71Installing a CD/DVD Drive1 If you are installing a new drive, unpack the drive and prepare it for installation.Check the documentation that accompanied the drive to verify that the drive is configured for yourcomputer. If you are installing an IDE drive, configure the drive for the cable select setting.2 If you are replacing a drive, remove the existing drive (see page 70).3 Gently slide the drive into place in the drive bay.4 After the drive is in place, apply pressure to ensure that the drive is fully seated.5 Use the securing screw that came with the drive to attach the drive to the computer.NOTICE: Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1").6 Connect the power cable to the system board (see page 53).7 Connect the power and CD/DVD drive cables to the drive and to the system board(see page 53).8 If you are installing a drive that has its own controller card, install the controller card in a card slot.9 Reattach the front panel (see page 62).10 Replace the computer cover (see page 75).NOTICE: To connect a network cable, first plug the cable in to the network wall jack and then plug it into thecomputer.11 Connect your computer and devices to their electrical outlets, and turn them on.See the documentation that came with the drive for instructions on installing any software required fordrive operation.12 Enter system setup (see "System Setup" on page 80) and select the appropriate Drive option.13 Verify that your computer works correctly by running Dell Diagnostics (see page 36).Adding a Second CD or DVD Drive1 Ensure that the jumper setting on the new drive is set for "cable select" (see the documentation thatcame with the drive for information).