Dell Dimension 4500 Manual

Also see for Dimension 4500: Owner's manual Owner's manual

Contents

Dell Dimension 4500 Manual Manual pdf 23 page image

These rails are not attached to the computer cover with screws. To remove the rails, firmly pull the rails from the drive cage.9. Attach the rails to the drive using the screws supplied with the drive.Ensure that the rail tabs are positioned at the back of the drive.10. Gently slide the drive into the bay until you hear a click.11. Carefully replace the drive bay cover.You do not need to replace the cover insert.12. Close the computer cover.13. Connect a power cable to the drive.See the documentation that came with the drive for instructions on connecting a drive cable to the drive.14. Connect your computer and devices to their electrical outlets, and turn them on.15. Install any drivers required for the drive as described in the documentation that came with the drive.Replacing the Microprocessor1. Shut down the computer.2. Turn off any attached devices and disconnect them from their electrical outlets.3. Disconnect the power cable from your computer, and then press the power button to ground the system board.HINT: Your computer uses cable-select drive cables. This means that the device connected to the end connector of the drive cable is the master deviceand the device connected to the middle connector is the slave device. Be sure that the jumper setting on the new device is set for "cable select" (seethe documentation that came with the drive for information).NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in "Safety Instructions."NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.