112 AppendixPower ManagementAC Recovery(Off default)Determines how the system responds when AC power is re-applied after apower loss.• Off — The system remains off when power is re-applied. You must pressthe front-panel power button before the system turns on.• On — The system turns on when power is re-applied.• Last — The system returns to the last power state the system was in justbefore it was turned off.Auto Power On(Off default)Sets the computer to automatically turn on.• Off — disables the Auto Power On feature• Everyday — turns the computer on every day at the time set in Auto PowerTime• Weekdays — turns the computer on every day from Monday throughFriday at the time set in Auto Power TimeNOTE: This feature does not work if you turn off your computer using a powerstrip or surge protector.Auto Power Time Sets time to automatically turn on the computer.Time is kept in the standard 12-hour format (hours:minutes). Change thestartup time by pressing the right- or left-arrow key to increase or decreasethe numbers, or type numbers in both the date and time fields.Suspend Mode(S3 default)Sets the computer’s suspend mode.• S1 — sets the computer to a suspend state where the computer is runningin a low-power mode• S3 — sets the computer to a standby state where the power is reduced orturned off for most components; however, system memory remains activefor both settingsMaintenanceSERR DMI Message(On default)Controls the SERR DMI message mechanism.NOTE: Some graphics cards require that the SERR DMI message mechanismbe disabled.Load Defaults Restores System Setup options to their factory defaults.Event Log Allows you to view the Event Log. Entries are marked R for Read and U forUnread. Mark All Entries Read puts an R to the left of all entries. ClearLog clears the Event Log.WD846bk2.book Page 112 Thursday, September 14, 2006 2:40 PM
