Dell EMC PowerEdge R640 WNW58 Installation And Service Manual

Trusted Platform ModuleUpgrading the Trusted Platform ModulePrerequisites1. Follow the safety guidelines listed in Safety instructions on page 34.2. Follow the procedure listed in Before working inside your system on page 35.NOTE:● Ensure that your operating system supports the version of the TPM module being installed.● Ensure that you download and install the latest BIOS firmware on your system.● Ensure that the BIOS is configured to enable UEFI boot mode.About this taskCAUTION: If you are using the Trusted Platform Module (TPM) with an encryption key, you may be promptedto create a recovery key during program or System Setup. Work with the customer to create and safely storethis recovery key. When replacing this system board, you must supply the recovery key when you restart yoursystem or program before you can access the encrypted data on your hard drives.CAUTION: Once the TPM plug-in module is installed, it is cryptographically bound to that specific system board.Any attempt to remove an installed TPM plug-in module breaks the cryptographic binding, the removed TPMcannot be reinstalled or installed on another system board.Removing the TPMSteps1. Locate the TPM connector on the system board.2. Press to hold the module down and remove the screw using the security Torx 8-bit shipped with the TPM module.3. Slide the TPM module out from its connector.4. Push the plastic rivet away from the TPM connector and rotate it 90° counterclockwise to release it from the system board.5. Pull the plastic rivet out of its slot on the system board.Installing the TPMSteps1. To install the TPM, align the edge connectors on the TPM with the slot on the TPM connector.2. Insert the TPM into the TPM connector such that the plastic rivet aligns with the slot on the system board.3. Press the plastic rivet until the rivet snaps into place.Installing and removing system components 129