Dell EMC XC Core XC750xa Installation And Service Manual

3. If installing GPU other than T4 into front GPU riser module then, replace the GPU bracket.4. If installing T4 GPU into front GPU riser module then, install the GPU riser module card holders.5. install the GPU into front GPU riser module or install the GPU into expansion card riser.NOTE: Mixing of different GPUs are not allowed.NOTE: See Expansion card installation guidelines to know about risers and slots that support GPU.NOTE: For information on riser slot location on the system board, see the System board jumpers and connectors topic.6. If applicable, connect the power cables to the GPU. To know the connectors for GPU on the system board, see theExpansion card installation guidelines topic.NOTE: Refer to the GPU power cable matrix to know about the requirement of cable for the GPU.Table 34. GPU power cable matrixCategory Description Type Vendor Cable Cable quantity Maximum persystemGPU CRD,GRPHC,NVIDIA,T4,16GB,70W,LHH and HL (FHand LP brackets)NVIDIA Not required Not required 6GPU NVIDIA VoltaNext 300W DWGPU (A100)-Gen4FH and FL NVIDIA 8 pin cable 1 piece per GPUriser4GPU Nvidia RTX-A40 FH and FL NVIDIA 8 pin cable 1 piece per GPUriser4HH - Half Height, HL - Half Length, FH - Full Height, FL - Full Length7. Install the GPU riser module or expansion card riser. See GPU kit components table for supported GPU risers.8. Install the air shroud.After installing, follow the After working inside your system instructions.Upgrade Kits 127