Dell EMC XC Core XC750xa Installation And Service Manual

iDRAC Quick Sync 2 indicator codesiDRAC Quick Sync 2 module (optional) is located on the left control panel of the system.Table 39. iDRAC Quick Sync 2 indicators and descriptionsiDRAC Quick Sync 2 indicatorcode Condition Corrective actionOff (default state) Indicates that the iDRAC Quick Sync 2feature is powered off. Press the iDRACQuick Sync 2 button to power on theiDRAC Quick Sync 2 feature.If the LED fails to power on, reseat the leftcontrol panel flex cable and check.Solid white Indicates that iDRAC Quick Sync 2 isready to communicate. Press the iDRACQuick Sync 2 button to power off.If the LED fails to power off, restart the system.If the problem persists, see the Getting helpsection.Blinks white rapidly Indicates data transfer activity. If the indicator continues to blink indefinitely, seetheGetting help section.Blinks white slowly Indicates that firmware update is inprogress. If the indicator continues to blink indefinitely, seetheGetting help section.Blinks white five times rapidlyand then powers offIndicates that the iDRAC Quick Sync 2feature is disabled.Check if iDRAC Quick Sync 2 feature isconfigured to be disabled by iDRAC. If theproblem persists, see the Getting help section.https://www.dell.com/poweredgemanuals.Solid amber Indicates that the system is in fail-safemode.Restart the system. If the problem persists, seethe Getting help section.Blinking amber Indicates that the iDRAC Quick Sync 2hardware is not responding properly.Restart the system. If the problem persists, seethe Getting help section.iDRAC Direct LED indicator codesThe iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRACsubsystem.You can configure iDRAC Direct by using a USB to micro USB (type AB) cable, which you can connect to your laptop ortablet. Cable length should not exceed 3 feet (0.91 meters). Performance could be affected by cable quality. The following tabledescribes iDRAC Direct activity when the iDRAC Direct port is active:Table 40. iDRAC Direct LED indicator codesiDRAC Direct LEDindicator code ConditionSolid green for twosecondsIndicates that the laptop or tablet is connected.Blinking green (on fortwo seconds and off fortwo seconds)Indicates that the laptop or tablet connected is recognized.LED Indicator off Indicates that the laptop or tablet is unplugged.134 System diagnostics and indicator codes