4. Install the I/O connector cover.Figure 44. Removing and Installing a CMC Module or iKVM Module (CMC Module Shown)1. I/O connector cover2. release latch3. release leverInstalling A CMC ModuleCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. Remove the I/O connector cover.2. Open the CMC module handle.3. Slide the module into the enclosure until the handle contacts the enclosure.4. To fully seat the module, close the handle until the release latch snaps into place.5. Reconnect the cables that were attached to the module.CMC Module SD CardThe SD card slot on the CMC module supports an optional WWN/MAC feature that allows slot-based WWN/MACs forthe blades, simplifying blade installation and replacement.NOTE: For a redundant CMC module system, install the SD card on the passive module. The blue status indicator onthe passive module is off.1. Remove the CMC module from the M1000e enclosure.NOTE: Verify the write protection latch is in the "unlock" position.2. Locate the SD card slot on the bottom of the CMC module and insert the contact-pin end of the card into the slotwith the label on the card facing upwards.82
