Figure 33. Removing and Installing the SD vFlash Card1. SD vFlash card2. SD vFlash card slot3. To install the SD vFlash card, with the label side facing up, insert the contact-pin end of the SD card into the cardslot on the module.NOTE: The slot is keyed to ensure correct insertion of the card.4. Press inward on the card to lock it into the slot.Internal Dual SD ModuleNOTE: When the Redundancy option is set to Mirror Mode in the Integrated Devices screen of the System Setup,the information is replicated from one SD card to another.Removing The Internal Dual SD ModuleCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet andperipherals.2. Open the system.3. Remove the expansion-card riser 1 and any card installed in the riser.4. Locate the internal dual SD module installed on the IDSDM connector on the system board.5. If applicable, remove the SD card(s).6. Holding the tab, pull the dual SD module to remove it from the system board.7. Replace the expansion-card riser 1 and if applicable, replace the card in the riser.8. Close the system.9. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.70
