Dell FC SAN User Manual

Dell FC SAN User Manual Manual pdf 13 page image

Dell 8/4Gbps FC SAN Module Hardware User’s Manual 1153-1001964-01Unpacking and installing the FC SAN Module 1SFPsNOTEYou must install Dell-supported SFPs in the FC SAN Module.The FC SAN Module was designed to work with small form-factor pluggable (SFP) optical modules.The FC SAN Module ships with two 8 Gbps SFPs installed. If you purchase a license for additionalports, you will receive additional SFPs.NOTEYou can also install 4 Gbps SFPs in the FC SAN Module, All SFPs must be Dell-supported.SFPs provide optical connections to external devices for both SWL and LWL connections. ReplaceSFPs with a new pluggable unit rather than replacing the FC SAN Module. Refer to themanufacturer’s instructions when installing SFPs.“Removing and replacing the FC SAN Module” on page 24 provides details about removing SFPsfrom the FC SAN Module.Unpacking and installing the FC SAN ModuleIf the FC SAN Module is installed in the Blade Enclosure that is shipped to you, skip this section.This section applies when installing a new module in an empty bay or replacing an existing FC SANModule.NOTEThe FC SAN Module is designed to work only in I/O bays B1/B2 and C1/C2 of the Dell M1000e BladeEnclosure. Make sure to comply with installation requirements in the Blade Enclosure HardwareOwner’s Manual.Perform the following steps to remove the FC SAN Module from its shipping package.1. Open the shipping box and inspect the contents, making sure that nothing is missing ordamaged.Do not insert a damaged FC SAN Module into the Blade Enclosure. If the FC SAN Moduleappears to be damaged, contact your sales representative before proceeding.2. Remove the cardboard accessory tray from on top of the FC SAN Module.This tray contains the documentation, regulatory statements, product information guide, andDocumentation CD.3. Remove the FC SAN Module from the box.The protective foam ends will slide out with the FC SAN Module.4. Remove the foam ends from the FC SAN Module.5. Be sure that you have taken the necessary precautions for electrostatic sensitivity; then breakthe seal warning.6. Slide the FC SAN Module out of the antistatic sleeve and inspect it carefully for any obviousdefects or shipping damage.