Dell FC SAN User Manual

Dell FC SAN User Manual Manual pdf 29 page image

Dell 8/4Gbps FC SAN Module Hardware User’s Manual 2753-1001964-01AppendixA8/4Gbps FC SAN Module specificationsThis appendix provides product specifications and regulatory compliance as a handy reference.Default port mappingThe Dell 8/4Gbps FC SAN Module can contain 24 total ports. Of these, F_Ports are ports 1-16 andN_Ports are ports 0 and 17-23.The FC SAN Module is operates in NPIV mode only. In NPIV mode, the FC SAN Module F_Ports aremapped to N_Ports. This following lists the factory-default F_Port to N_Port mapping for NPIVmode. Since the FC SAN Module is shipped with Dynamic port licensing enabled, any out of the 24ports can be enabled. Therefore this mapping applies for 12 active ports or, if a port upgradelicense is enabled, for 24 ports. For more information on changing port mapping and managingports in NPIV mode, refer to the Dell 8/4Gbps FC SAN Module Administrator's Guide.• 17-23, 0 as N_Port with failover enabled, failback enabled• 1, 2 mapped to 17• 3, 4 mapped to 18• 5, 6 mapped to 19·• 7, 8 mapped to 20• 9, 10 mapped to 21·• 11, 12 mapped to 22·• 13, 14 mapped to 23·• 15, 16 mapped to 0Processor and memory specificationsThe processor and memory installed in the 8/4Gbps FC SAN Module are shown in Table 3.TABLE 3 Memory SpecificationsMemory Type ValuePowerPC 440EPX processor 667 MHzSDRAM 512 MB DDR2 - for system memory at 64 bitswide with 8 ECC operating at 166 MHzBoot flash 4 MBCompact flash 512 MB