Dell FC SAN User Manual

Dell FC SAN User Manual Manual pdf 17 page image

Dell 8/4Gbps FC SAN Module Hardware User’s Manual 1553-1001964-01Modify the FC SAN Module IP address 2e. From the COM Port Properties window, select the following configuration values:• Bits per second: 9600• Databits: 8• Parity: None• Stop bits: 1• Flow Control: NoneFor LINUX or UNIXa. Enter the following at the command prompt:tip /dev/ttyb -9600b. When the terminal application stops reporting information, press Enter to display the loginprompt.c. Log in to the default administrative account using the following identification:Login: adminPassword: passwordd. When prompted either change the administrative password, or press Ctrl-C to bypass.Task 2: Changing the IP address1. Verify that the FC SAN Module has completed POST. When POST is complete, the port statusand FC SAN Module power and status LEDs return to a standard healthy state.2. Enter the CLI ipAddrSet command.Follow on-screen instructions and supply the correct information, as shown in the followingexample.switch:admin> ipaddrsetEthernet IP Address [10.77.77.77]:10.32.53.47Ethernet Subnetmask [255.255.255.0]:255.255.240.0Fibre Channel IP Addresss [none]:Fibre Channel Subnetmask [none]:Gateway IP Address [0.0.0.0]:10.32.48.1DHCP [Off]:IP address is being changed...Done.3. Enter ipAddrShow at the prompt to verify that the address was correctly set.Using the CMC CLI to set the IP addressUse the following steps to connect modify the FC SAN Module IP address through the CMC CLI.1. Establish a Telnet session to the CMC CLI.