Dell Inspiron 14 AMD M4010 Service Manual

Also see for Inspiron N4010: User guide Setup guide Service manual

12. Make a note of the Mini-Card antenna cables and display cable routing and remove the cables from the routing guides.13. Hold the display assembly in place and remove the four screws that secure the display assembly to the computer base.14. Lift and remove the display assembly out of the computer base.Replacing the Display Assembly1. Follow the instructions in Before You Begin.2. Place the display assembly in position and replace the four screws (two on each side) that secure the display assembly to the computer base.3. Route the Mini-Card antenna cables and display cable through the routing guides.4. Connect the display cable to the connector on the system board, and replace the display cable grounding screw.5. Connect the antenna cables to the Mini-Card(s) (see Replacing the Mini-Card(s)).6. Close the display and turn the computer over.7. Replace the two screws that secure the display assembly to the computer base.8. Replace the palm rest (see Replacing the Palm Rest).9. Replace the keyboard (see Replacing the Keyboard).10. Replace the memory module(s) (see Replacing the Memory Module(s)).11. Replace the module cover (see Replacing the Module Cover).12. Follow the instructions from step 4 to step 5 in Replacing the Optical Drive.13. Replace the battery (see Replacing the Battery).Display Bezel1 display cable grounding screw 2 display cable3 Mini-Card antenna cables 4 screws (4)5 display assemblyCAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so mayresult in damage to the computer.