Back to Contents PageInternal Card With Bluetooth® Wireless TechnologyDell™ Inspiron™ N4010 Service ManualRemoving the Bluetooth CardReplacing the Bluetooth CardIf you ordered a card with Bluetooth wireless technology with your computer, it is already installed.Removing the Bluetooth Card1. Follow the instructions in Before You Begin.2. Remove the battery (see Removing the Battery).3. Follow the instructions from step 3 to step 4 in Removing the Optical Drive.4. Remove the module cover (see Removing the Module Cover).5. Remove the memory module(s) (see Removing the Memory Module(s)).6. Remove the keyboard (see Removing the Keyboard).7. Remove the palm rest (see Removing the Palm Rest).8. Remove the screw that secures the Bluetooth card to the system board.9. Lift the Bluetooth card to disconnect it from the connector on the system board.Replacing the Bluetooth Card1. Follow the instructions in Before You Begin.2. Align the connector on the Bluetooth card with the connector on the system board and press the Bluetooth card until it is fully seated.3. Replace the screw that secures the Bluetooth card to the system board.WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metalsurface (such as a connector on your computer).CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside thecomputer.1 Bluetooth card 2 screw