Back to Contents PageDisplayDell™ Inspiron™ 1410 Service ManualDisplay AssemblyDisplay BezelDisplay PanelDisplay Panel CableDisplay InverterDisplay AssemblyRemoving the Display Assembly1. Follow the instructions in Before Working Inside Your Computer2. Remove the memory module(s) (see Removing the Memory Module(s)).3. Remove the WLAN card (see Removing the WLAN Card).4. Remove the center control cover (see Removing the Center Control Cover).5. Remove the keyboard (see Removing the Keyboard).6. Remove the mylar tapes and then remove the two screws from the back of the computer.7. Pull the display cable tab to disconnect the display cable from the system board connector.8. Make note of the cable routing and carefully dislodge the WLAN antenna cables and the rest of the cables from their routing guides. Pull the cablesaway, so that they are clear of the palm rest.CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (suchas a connector on the back of the computer).NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside thecomputer.NOTE: Note how the display cable is routed through their routing guides.