Dell Inspiron 1410 Service Manual

Also see for Inspiron 1410: User guide Setup guide

9. Remove the two screws from either side of the display hinges.10. Lift and remove the display assembly.Replacing the Display Assembly1. Place the display assembly in place and replace the two screws on each side of the display hinges.2. Re-route and connect the display cable to the connector on the system board.3. Carefully route the WLAN antenna cables into their routing guides on the palm rest and through the computer base.4. Replace the keyboard (see Keyboard).5. Replace the two screws at the back of the computer.6. Turn the computer over and carefully route the WLAN card antenna cables through their routing guides and connect them to the WLAN card.7. Reconnect the WLAN card if applicable (see Replacing the WLAN Card).8. Replace the memory modules (see Replacing the Memory Module(s)).9. Slide the battery into the battery bay, until it clicks in place.1 display cable 2 antenna cables1 display hinge screw (4) 2 antenna cables3 display cableCAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.