Dell Inspiron 535 Service Manual

Also see for Inspiron 535: Setup guide

6. Slide the media card reader out through the front of the computer.7. Replace the bezel (see Replacing the Front Bezel).8. Replace the computer cover (see Replacing the Computer Cover).9. Connect your computer and devices to electrical outlets, and then turn them on.Replacing a Media Card Reader1. Follow the procedures in Before You Begin.2. Remove the computer cover (see Removing the Computer Cover).3. Remove the bezel (see Removing the Front Bezel).4. If this is a new media card reader installation, remove the break-away metal plate. Align the tip of a Phillips screwdriver with the slot on the break-awaymetal plate and rotate the screwdriver outwards to break and remove the metal plate.5. Gently slide the media card reader into place in the FlexBay slot.6. Align the screw holes in the media card reader with the screw holes in the FlexBay slot.7. Replace the two screws that secure the media card reader to the FlexBay slot.8. Connect the FlexBay USB cable and power cable to the back of the media card reader.9. Connect the FlexBay USB cable to the internal USB connector on the system board (see System Board Components).10. Replace the bezel (see Replacing the Front Bezel).11. Replace the computer cover (see Replacing the Computer Cover).12. Connect your computer and devices to electrical outlets, and then turn them on.Removing an Optical Drive1. Follow the procedures in Before You Begin.2. Remove the computer cover (see Removing the Computer Cover).3. Remove the bezel (see Removing the Front Bezel).4. Disconnect the power cable and the data cable from the back of the optical drive.NOTE: Ensure that the media card reader is installed before the FlexBay USB cable is connected.NOTE: If you are not replacing the optical drive at this time, disconnect the other end of the data cable from the system board and set it aside.You can use the data cable to install an optical drive at a later time.