Dell Inspiron 535 Service Manual

Also see for Inspiron 535: Setup guide

Back to Contents PageMemoryDell™ Inspiron™ 535/537/545/546 Service ManualRemoving MemoryReplacing MemoryRecommended Memory ConfigurationSetting Up Dual Channel Memory ConfigurationRemoving Memory1. Follow the procedures in Before You Begin.2. Remove the computer cover (see Removing the Computer Cover).3. Locate the memory modules on the system board (see System Board Components).4. Press out the securing clip at each end of the memory module connector.5. Grasp the memory module and pull it upwards.If the memory module is difficult to remove, gently ease the memory module back and forth to remove it from the connector.Replacing Memory1. Follow the procedures in Before You Begin.2. Press out the securing clip at each end of the memory module connector.3. Follow the memory installation guidelines (see Recommended Memory Configuration).4. Align the notch on the bottom of the memory module with the tab in the connector.WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.WARNING: Do not operate your equipment with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)removed.1 memory module connector 2 securing clipCAUTION: Do not install ECC memory modules.1 cutouts (2) 2 tab