Back to Contents PageBefore You BeginDell™ Inspiron™ 535/537/545/546 Service ManualTechnical SpecificationsRecommended ToolsTurning Off Your ComputerSafety InstructionsThis chapter provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that thefollowing conditions exist:l You have performed the steps in Turning Off Your Computer and Safety Instructions.l You have read the safety information that ships with your computer.l A component can be replaced or—if purchased separately—installed by performing the removal procedure in reverse order.Technical SpecificationsFor information on technical specifications of your computer, see the Setup Guide that shipped with your computer or see the Dell Support website atsupport.dell.com.Recommended ToolsThe procedures in this document may require the following tools:l Small Phillips screwdriverl Small flat-blade screwdriverTurning Off Your Computer1. Shut down the operating system.2. Ensure that the computer and all attached devices are turned off. If your computer and attached devices did not automatically turn off when you shutdown your operating system, press and hold the power button for about 4 seconds to turn them off.Safety InstructionsUse the following safety guidelines to help protect your computer from potential damage and to help to ensure your own personal safety.1. Ensure that the work surface is flat and clean to prevent the computer cover from being scratched.2. Turn off your computer (see Turning Off Your Computer).3. Disconnect all telephone or network cables from the computer.CAUTION: To avoid losing data, save and close all open files and exit all open programs before you turn off your computer.WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell isnot covered by your warranty.CAUTION: When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with lockingtabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keepthem evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly orientedand aligned.CAUTION: To avoid damaging the computer, perform the following steps before you begin working inside the computer.CAUTION: To disconnect a network cable, first unplug the cable from your computer and then unplug the cable from the network device.