Back to Contents PageBatteryDell™ Inspiron™ 560/570 Service ManualRemoving the BatteryReplacing the BatteryRemoving the Battery1. Record all the screens in System Setup (see System Setup) so that you can restore the correct settings after the new battery has been installed.2. Follow the procedures in Before You Begin.3. Remove the computer cover (see Removing the Computer Cover).4. Locate the battery socket (see System Board Components).5. Press the battery release lever to remove the battery.Replacing the Battery1. Follow the procedures in Before You Begin.2. Insert the new battery (CR2032) into the socket with the side labeled "+" facing up, and press the battery into place.3. Replace the computer cover (see Replacing the Computer Cover).4. Connect your computer and devices to electrical outlets, and then turn them on.WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.WARNING: A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by themanufacturer. Discard used batteries according to the manufacturer's instructions.WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.WARNING: Do not operate your equipment with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)removed.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.CAUTION: If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with the object. Ensure that theobject is inserted between the battery and the socket before you attempt to pry out the battery. Otherwise, you may damage the system board byprying off the socket or by breaking circuit traces on the system board.1 battery release lever