Dell Inspiron 560 Service Manual

Back to Contents PageProcessorDell™ Inspiron™ 560/570 Service ManualRemoving the ProcessorReplacing the ProcessorRemoving the Processor1. Follow the procedures in Before You Begin.2. Remove the computer cover (see Removing the Computer Cover).3. Remove the processor fan and heat sink assembly from the computer (see Removing the Processor Fan and Heat Sink Assembly).4. Press and push the release lever down and out to release it from the tab that secures it.5. Open the processor cover, if applicable.Inspiron™ 560Inspiron 570WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.WARNING: Do not operate your equipment with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)removed.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell isnot covered by your warranty.CAUTION: Do not perform the following steps unless you are familiar with hardware removal and replacement. Performing these stepsincorrectly could damage your system board. For technical service information, see the Setup Guide.CAUTION: Despite having a plastic shield, the heat sink assembly may be very hot during normal operation. Be sure that it has had sufficient timeto cool before you touch it.NOTE: Unless a new heat sink is required for the new processor, reuse the original heat sink assembly when you replace the processor.1 processor cover 2 processor3 socket 4 release lever