Dell Inspiron 560 Service Manual

Back to Contents PageSystem BoardDell™ Inspiron™ 560/570 Service ManualRemoving the System BoardReplacing the System BoardRemoving the System Board1. Follow the procedures in Before You Begin.2. Remove the computer cover (see Removing the Computer Cover).3. Remove any PCI and PCI Express cards on the system board (see Removing PCI and PCI Express Cards).4. Remove the processor fan and heat sink assembly (see Removing the Processor Fan and Heat Sink Assembly).5. Remove the processor (see Removing the Processor).6. Remove the memory modules (see Removing the Memory Module(s)) and document which memory module is removed from each memory-moduleconnector so that the memory modules can be installed in the same location after the board is replaced.7. Disconnect all cables from the system board. Note the routing of all cables as you remove them so that you can re-route them correctly after installingthe new system board.8. Remove the eight screws that secure the system board to the chassis.9. Lift the system board up and out of the chassis.Inspiron 560Inspiron 570WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety bestpractices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.WARNING: Do not operate your equipment with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)removed.CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™is not covered by your warranty.1 screws (8) 2 system board